Cleaning Or Replacing The Uv Lamps In The Side Section; Cleaning Or Replacing The Uv Lamps In The Shoulder Tanner - ergoline AFFINITY 500 SUPER POWER Gebrauchsanweisung

Cleaning and maintenance
50
The assembly is the same process in reverse order.
When assembling the device please note:
– Support the canopy panel with one hand so that it does not fall down.
– Refit and retighten the screws. Refit the middle screws first and then the
outer screws.
5.12 Cleaning or replacing the UV lamps in
the side section
– Removing the side section panel: see page 42.
Replacing the lamps: see page 45.
Replacing the starter (AFFINITY 500, 600, 800): see page 46.
Changing the chip card (AFFINITY 660): see page 44.
UV high pressure lamps and filter panels: see page 47.
When assembling the device please note:
– Refit and retighten the screws.
5.13 Cleaning or replacing the UV lamps in
the shoulder tanner
– Opening the bed base: see page 43.