Yamaha RX-V565 Bedienungsanleitung Seite 53

Problem
No picture. An appropriate video input is not selected
on the monitor.
The composite output terminals are used
to output a component video signal, or the
COMPONENT VIDEO jacks are used to
output a composite video signal.
This unit outputs the video signals are not
supported on the video monitor connected
to the HDMI OUT jack.
Non-standard video signals are input.
The sound suddenly
The protection circuitry has been activated
goes off. because of a short circuit, etc.
The sleep timer has turned off this unit.
Sound is heard from The playback component or speakers are
the speaker on one
not connected properly.
side only.
The speaker level settings are incorrect.
Only the center
When a monaural source sound field
speaker outputs program is applied, sound of all channels
substantial sound. are output from the center speaker for
some surround decoders.
No sound is output Output from that speaker is disabled.
from a specific
speaker.
The volume of that speaker is set to
minimum in Speaker Setup in the Setup
menu.
This unit or speaker is malfunction.
No sound is heard This unit is in the "STRAIGHT" mode
from the surround
and a monaural source is being played
speakers. back.
Sound may not be output from certain
channels depending on input sources or
sound field programs.
Cause
Select an appropriate video input on the monitor.
If your monitor does not support the HDMI
connection, connect it to the COMPONENT OUT
jacks or the composite output terminals and select an
appropriate video input on the monitor.
Displays the advanced setup menu and select
"VIDEO" in "INIT" to reset the video parameters.
Displays the advanced setup menu and set
"MON.CHK" to "YES."
Connect the monitor to this unit via the
COMPONENT OUT jacks or the composite output
terminals.
Check that the speaker wires are not touching each
other and then turn this unit back on.
Turn on this unit, and play the source again.
Connect the cables properly. If the problem persists,
the cables may be defective.
Adjust "B)Level" settings.
Try another sound field program.
Check the Speaker indicators on the front panel
display. If the corresponding indicator is turned off,
try the following.
1) Change the input source to another one.
2) With the selected sound field program, sound is not
output from that speaker. Select another sound field
program.
3) "None" may have been selected for that speaker on
this unit. Display Speaker Setup in the Setup menu
and enables output of that speaker.
Display Speaker Setup in the Setup menu and adjust
the volume (2 Manual Setup→B)Level).
Check the Speaker indicators on the front panel
display. If the corresponding indicator lights up,
connect another speaker and check if sound is output.
If sound is not output, this unit may be malfunction.
Press LSTRAIGHT or the jSTRAIGHT on the
remote control to turn off the "STRAIGHT" mode.
Try another sound field program.
Troubleshooting
Remedy
See
page
—
14
47
47
14
—
—
11
43
24
6, 21, 24,
42
43
6, 10
27
24
49
En