Connecting The Fm And Am Antennas; Connecting The Power Cable; Turning This Unit On And Off - Yamaha RX-V565 Bedienungsanleitung

Connecting the FM and AM antennas

An indoor FM antenna and an AM loop antenna are
supplied with this unit. Connect these antennas properly to
the respective jacks.
Indoor FM antenna
Outdoor AM antenna
Connect a 5 to 10 m (16
to 33 ft) vinyl-covered
wire, and extend it
outdoors (use the AM
loop antenna together
with this antenna).
DOCK HDMI
COMPONENT
VIDEO
UNBAL.
P
R
S VIDEO
FM
P
B
VIDEO
Y
Ground (GND terminal)
The GND terminal is not for earth
grounding.
To reduce noises, connect a ground bar or a
vinyl-covered wire with a copper plate at its
tip, and place it in the moist ground.
y
• The supplied antennas are normally sensitive enough to obtain good
reception.
• Position the AM loop antenna away from this unit.
• If you cannot get good reception, we recommend that you use an outdoor
antenna. For more details, consult the nearest authorized Yamaha dealer
or service center.
• Always use the AM loop antenna even when the outdoor antenna is
connected.
Assembling the AM loop antenna
Connecting the AM loop antenna
The wires of the AM loop antenna have no polarity. You
can connect either wire to the AM terminal and the other
to the GND terminal.
Press and hold Insert
AM loop
antenna
(BD/DVD)
OUT HDMI 1 HDMI 2 HDMI 3
ANTENNA
F
COMPONENT
VIDEO
P
R
GND AM
P
B
VIDEO
Y
MONITOR OUT
Release

Connecting the power cable

After all connections are complete, plug the AC power
cable of this unit into an AC wall outlet.

Turning this unit on and off

1
Press ASTANDBY/ON (or fPOWER) to
turn on this unit.
2
Press ASTANDBY/ON (or fPOWER) again
to turn off this unit (standby mode).
y
• The unit needs a few seconds until ready to play back.
• You can also turn on this unit by pressing ISCENE (or kSCENE).
• This unit consumes a small amount of electricity even in the standby
mode. We recommend disconnecting the power cable from the AC wall
outlet.
Caution
Do not unplug this unit while it is turned on. Doing so
may damage this unit or cause the settings of this unit
to be saved incorrectly.
Connections
To the AC wall outlet
Power cable
17
En