Yamaha RX-V565 Bedienungsanleitung Seite 58

Troubleshooting
Error message
E-4:SBR->SBL
E-5:NOISY
E-6:CHECK SUR.
E-7:NO MIC
E-8:NO SIGNAL
E-9:USER CANCEL
E-10:INTERNAL ERROR
After Auto Setup
Error message
W-1:OUT OF PHASE
W-2:OVER 24m (80ft)
W-3:LEVEL ERROR
54
En
Cause
Only right surround back channel signal
is detected.
Measurement cannot be performed
accurately due to loud ambient noise.
Surround back speakers are connected,
though surround L/R speakers are not.
The optimizer microphone was
unplugged during the "Auto Setup"
procedure.
The optimizer microphone does not
detect test tones.
"Auto Setup" was cancelled due to an
inappropriate user operation.
An internal error occurred.
Cause
Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
The distance between the speaker and the
listening position is over 24 m (80 ft).
The difference of volume level among
speakers is excessive.
Remedy
If you connect only one surround back speaker,
connect it to the L-side (SINGLE) terminal.
Try running "Auto Setup" in a quiet environment.
Turn off noisy electric equipment like air
conditioners or move them away from the optimizer
microphone.
When using surround back speakers, you need to
connect surround L/R speakers.
Do not touch the optimizer microphone during "Auto
Setup."
Check whether the microphone is properly placed.
Check whether the speakers are properly placed and
connected.
The optimizer microphone or OPTIMIZER MIC
jack may be defective. Contact the nearest Yamaha
dealer or service center.
If a monitor such as a TV is connected to this unit
via HDMI connection, sound may not be output
from this unit due to the HDMI control function. In
such a case, change the monitor setting, for example,
change the sound output setting to an amplifier so
that sound is output from this unit.
Run "Auto Setup" again.
Run "Auto Setup" again.
Remedy
Check the polarities (+, –) of the displayed speaker.
If they are correct, the speakers work properly even
when this message is displayed.
Bring the speaker within 24 m (80 ft.) area around
the listening position.
Recheck the speaker positions and make sure all
speakers are placed in a similar environment.
Check the polarities (+, –) of the speakers.
We recommended that you use speakers with the
same or similar specifications.
Adjust the output volume of the subwoofer.
See
page
11
—
—
11
18
18
11
18
—
18
18
See
page
11
—
—
11
—
—