Yamaha RX-V565 Bedienungsanleitung Seite 54

Troubleshooting
Problem
No sound is heard
from the subwoofer.
No sound is heard
from the surround
back speakers.
The audio input
sources cannot be
played in the desired
digital audio signal
format.
Noise/hum noise is
heard.
"Memory Guard!" is
displayed and the
setting cannot be
changed.
This unit does not
operate properly.
"CHECK SP WIRES!"
appears on the front
panel display.
There is noise
interference from
digital or radio
frequency equipment.
50
En
Cause
"LFE/Bass Out" of "A)Config" in
"Speaker Setup" of the setup menu
(Speaker Setup→2 Manual
Setup→A)Config) is set to "Front" when
a Dolby Digital, DTS or AAC signal is
being played.
"LFE/Bass Out" of "A)Config" in
"Speaker Setup" of the setup menu
(Speaker Setup→2 Manual
Setup→A)Config) is set to "SWFR" or
"Front" when a 2-channel source is being
played.
The source does not contain low
frequency signals.
"Extended Surround" in the OPTION
menu is set to "Off," or an input signal
does not contain a surround back flag with
"Extended Surround" set to "Auto."
The connected component is not set to
output the desired digital audio signals.
Incorrect cable connection.
A DTS-CD is being played back.
"Memory Guard" in "Setup Menu" is set
to "On."
The internal microcomputer is frozen due
to an external electric shock (such as
lightning or excessive static electricity) or
by a drop in power supply voltage.
Speaker cables are short-circuited.
This unit is too close to other digital or
radio frequency equipment.
Remedy
Set "LFE/Bass Out" to "SWFR" or "Both."
Set "LFE/Bass Out" to "Both."
Set "Extended Surround" other than "Off" or "Auto."
Set the playback component properly referring to its
operating instructions.
Connect the audio cables properly. If the problem
persists, the cables may be defective.
1) When only noise is output
If a DTS bitstream signal is not properly input to this
unit, only noise is output. Connect the playback
component to this unit by digital connection and play
back the DTS-CD. If the condition is not improved,
the problem may results from the playback
component. Consult the manufacturer of the playback
component.
2) When noise is output during playback or skip
operation
Before playing back the DTS-CD, display the option
menu after selecting the input source and set
"Decoder Mode" to "DTS."
Set "Memory Guard" to "Off."
Disconnect the power cable from the AC wall outlet,
wait about 30 seconds and then plug it in again.
Make sure all speaker cables are connected correctly.
Move this unit further away from such equipment.
See
page
41
41
42
—
—
16, 36
45
—
12
—