Connection - Kenwood KDC-BT35U Bedienungsanleitung

Wiring connection
Antenna terminal
Connecting the ISO connectors on some VW/Audi or
Opel (Vauxhall) automobiles
You may need to modify the wiring of the supplied
wiring harness as illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function
A4 Yellow : Battery
A5 Blue/White : Power control
A7 Red : Ignition (ACC)
A8 Black : Earth (ground) connection
B1 Purple ]
: Rear speaker (right)
Purple/black [
B2
Gray ]
B3
: Front speaker (right)
Gray/black [
B4
B5 White ]
: Front speaker (left)
B6 White/black [
Green ]
B7
: Rear speaker (left)
Green/black [
B8
Rear/subwoofer output
Yellow (Battery wire)
Ignition wire
Red (Ignition wire)
(Red)
Unit
Battery wire
(Yellow)
Red (A7)
Yellow (A4)
When connecting to an external amplifier, connect its ground
wire to the car's chassis to avoid damaging the unit.
Fuse (10 A)
Microphone input jack ( 8)
If no connections are made, do not let the
wire come out from the tab.
STEERING WHEEL
Light blue/yellow
REMOTE INPUT
(Steering remote
REMOTE CONT
control wire)
ANT CONT
Blue/White
(Power control
P. CONT
wire/ Antenna
control wire)
Brown
(Mute control wire) MUTE
ISO connectors
Part list for
installation
(A) Faceplate
(B) Trim plate
To the steering wheel
(C) Mounting sleeve
remote control adapter
To the power control
terminal when using the
optional power amplifier
or to the antenna control
(D) Wiring harness
terminal in the vehicle
To connect the Kenwood
navigation system, refer
your navigations manual
(E) Extraction key
21
ENGLISH