Santec VTC-HDH422PWD Bedienungsanleitung Seite 30

Note:
At the installation, please ensure that the little holes next to the screws are not blocked or
clogged! In case of backwater, these little holes ensure that the water leaves the camera
housing.
4. Adjustments
Lens adjustment: (picture 6)
Lens control (focal length and focus) is done by the two setting rings. Carefully loosen the
two safety screws a bit so that you are able to turn the setting rings. Adjust the lens
according to your needs. Finally, seize the two safety screws again carefully.
OSD:
The camera adjustments are done by an OSD (on-screen-display) menu. On the board of the
camera you will find a mini-joystick. Press onto this joystick and a menu pops up in the video
picture. You can now move the joystick left/right/up/down in order to get to the desired menu
item. To confirm your selection, press onto the joystick.
(For camera VTC-HDH444PWDU it is also possible to set the OSD by using the RS-485
connection.)
See chapter "Camera adjustments via OSD menu" for further details.
Additional video connection: (picture 6)
This additional video connector can be used with the included adapter, e.g. if you want to
install a monitor during the installation phase in case the regular video cable has already
been laid.
Having made all adjustments, close the housing again. Make sure that the rubber gasket is
not damaged.
_________________________________________________________________________________
Bedienungsanleitung / User manual VTC-HDH422PWD /
VTC-HDH432IRPWD / VTC-HDH444PWDU
- 30 -