Connecting The Power Cord - Pioneer AVH-X8600BT Installationsanleitung

Connecting the power cord

Pioneer
RGB cable(Supplied with Navigation system)
navigation
system
Please contact your dealer to
inquire about the connectable
navigation unit.
Note:
Depending on the kind of vehicle,
the function of 2* and 4* may be
different. In this case, be sure to
connect 1* to 4* and 3* to 2*.
2* 1*
Connect leads of the same
4* 3*
colour to each other.
Yellow (2*) Yellow (1*)
Back-up Connect to the constant 12 V
(or accessory) supply terminal.
Red (4*) Red (3*)
Accessory Connect to terminal controlled by
(or back-up) ignition switch (12 V DC).
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
ISO connector
Note:
In some vehicles, the ISO connector may be divided into
two. In this case, be sure to connect to both connectors.
4 m
This product
Aerial jack
Power supply
Fuse (10 A) Power cord
Speaker leads
White: Front left
White/black: Front left
Grey: Front right
Grey/black: Front right
Green: Rear left or subwoofer
Green/black: Rear left or subwoofer
Violet: Rear right or subwoofer
Violet/black: Rear right or subwoofer
Microphone
Vehicle Bus adapter input
Please refer to the instruction manual for the Vehicle Bus adapter (sold separately).
Vehicle Bus onversion cable 15.8 cm
Wired remote input
Hard-wired remote control adapter can be connected (sold separately).
Violet/white
Of the two lead wires connected to the back lamp, connect the one in which the
voltage changes when the gear stick is in the REVERSE (R) position. This connection
enables the unit to sense whether the car is moving forwards or backwards.
Yellow/black
If you use an equipment with Mute function, wire this lead to the Audio Mute lead on
that equipment. If not, keep the Audio Mute lead free of any connections.
Connection method
1. Clamp the lead.
Note:
· The position of the hand brake switch depends on the vehicle model. For details, consult
the vehicle Owner's Manual or dealer.
Light green (PARKING BRAKE)
Used to detect the ON/OFF status of the handbrake. This lead must
be connected to the power supply side of the handbrake switch.
Blue/white
Connect to system control terminal of the
power amp (max. 300 mA 12 V DC).
Blue/white (6*)
Blue/white (5*) Connect to auto-aerial relay control terminal
(max. 300 mA 12 V DC).
The pin position of the ISO
Notes:
connector will differ depending on
· Change the initial setting of this unit. The subwoofer output of this unit
the type of vehicle. Connect 5* and
is monaural.
6* when Pin 5 is an aerial control
· When using a subwoofer of 70 W (2 Ω) , be sure to connect with Violet
type. In another type of vehicle,
and Violet/black leads of this unit. Do not connect anything to Green
never connect 5* and 6*.
and Green/black leads.
2. Clamp firmly with
needle-nosed pliers.
Handbrake
switch
Power supply side
Earth side
3
Engb