Initial Installation; Select Source; Connect External Devices - AEG CTV 2601 LCD/DVB-T Bedienungsanleitung

4.5 Initial Installation

When turning the TV set on for the first time a window is displayed to
select the menu language and to start auto scan.
1. Switch on the TV set with the main switch at the back of the
device to the right. When the indicator light turns red, press the
POWER button on the remote control. The "Select OSD Lan-
guage" window is displayed.
2. Press OK to confirm German as OSD language or press the arrow
buttons / / / on the remote control and OK to select your
language.
3. Press the arrow buttons / / / to select the country of your location.
4. Press OK to start Auto Tuning. This process will take a few minutes. Progress is displayed on screen.
5. After auto scan is finished channel 1 is shown.
6. After a few seconds the window will disappear or press EXIT to close the window.

4.6 Select Source

5. Connect External Devices

Your TV set features a variety of connectors for different devices (e.g. DVD recorder, PC, camera and set top box).
IMPORTANT! Ensure that your TV set and all devices to be connected are turned off before connection. Observe the user
manuals of devices to be connected.
SCART Connector
The SCART connector at the rear transmits analogue image and sound signals in good quality. Connect here devices such
as VCR, satellite receiver, game console or Pay-TV decoder.
• Connect the device via full-featured SCART cable to the SCART connector.
• In the source menu (press SOURCE button) select SCART.
VIDEO Connectors
Connect, for example, a video camera to the RCA inputs L and R and AV1 on the back or L and R and VIDEO (AV2) on the
right hand side.
• Connect the device via RCA cable to AV1, L and R or VIDEO, L and R.
IMPORTANT! Observe the colour coding of the cables when using AV cable (video = yellow, audio L = white and audio R = red).
• Select signal input AV 1 or AV 2 in the source menu (press SOURCE button).
PC Connector
• Use a VGA cable to connect the monitor connector of the PC with the VGA connector on the TV set.
• Use an audio cable to connect the audio connector of the PC with PC AUDIO INPUT on the TV set.
• In the source menu (press SOURCE button) select PC.
1. In on mode press the SOURCE button. The source menu (connected devices) is dis-
played.
2. Press the arrow buttons / on the remote control or CH +/- on the device to select
the desired source.
3. Press OK or VOL +/- on the device to confirm.
NOTE:
Press the EXIT button to exit the menu without changes.
ENGLISH
55