Basic Operation; Turn Tv Set On/Off; Select Channel; Adjust Volume - AEG CTV 2601 LCD/DVB-T Bedienungsanleitung

ENGLISH
56
Component Connector
The component connector Y Pb Pr transmits analogue image signals of external devices, e.g. AV receiver or DVD recorder
in very good quality.
• Use a component cable (purchase separately at your dealer) with 3 RCA connectors to connect component output of
the external device with the inputs Y Pb Pr on the TV set.
• Use an audio cable to connect the audio output of the external device with the audio connectors AUDIO INPUT L and
R on the TV set.
• In the source menu (press SOURCE button) select YPbPr.
HDMI- Inputs
Digital video and audio signals are transmitted in high quality from external devices via the HDMI ports.
• Use an HDMI cable (not supplied) to connect the HDMI output of the external device with one of the HDMI inputs on
the TV set.
• Select signal input HDMI1 or HDMI2 in the source menu (press SOURCE button).

6. Basic Operation

All settings can be performed comfortably with the remote control and the OSD menu. The basic functions can also be
performed with the buttons on the TV set. In this user manual we generally describe operation with remote control.

6.1 Turn TV Set On/Off

• Switch on the TV set with the main switch on the back of the device to the right. It starts in the previously selected
mode and selected source. In standby mode (status indicator red) press the POWER
The indicator light turns green and the device is switched on.
• Perss the POWER
button on the remote control to turn the device off again (standby mode).
• Switch the TV set off completely with the main switch back of the device to the right.
NOTE:
Turn the TV set off completely if you are not using it, as it uses a small amount of power in standby mode. Even after
turning the device off with the main switch it is not completely disconnected from mains power supply. For this you
must disconnect the power plug from the wall outlet.

6.2 Select Channel

• Press the CH +/- buttons or numeric buttons 0-9 to select the desired channel.
• Press the RECALL button on the remote control to return to the previous channel.
• Press CH.LIST to display the channel list. Press the arrow buttons (
display the channel on screen.

6.3 Adjust Volume

• Press the VOL +/-, buttons to adjust the volume.
• Press the MUTE button to temporarily mute the sound. Press MUTE or VOL + to unmute the sound again.

6.4 Shortcuts

AUDIO
Select audio language (only if supported by broadcaster)
SOURCE Select external device
PIC
Select picture mode
SOUND Select sound mode
SLEEP Set sleep timer
ASPECT Select aspect ratio
TEXT Access Teletext
INFO
Display channel information
SUBTITLE Select subtitle language (only if supported by broadcaster)
button on the remote control.
) to highlight a channel and press OK to