Preparation; Scope Of Delivery; Insert Batteries; Installation - AEG CTV 2202 Bedienungsanleitung

Cleaning and Maintenance
• Only use a soft and dry cloth for cleaning.
Batteries
• Batteries may contain toxins. Batteries
must not fall into the hands of children.
Children may place batteries in their mouths
and swallow them. Immediately contact a
physician if batteries were swallowed.
• Danger of explosion! Do not mix different
battery types or brands. Do not mix fresh
and exhausted batteries or batteries with
different capacity.
• Do not charge the supplied batteries. Do not
dismantle, short-circuit or burn batteries.
• Remove exhausted batteries from the
remote control to prevent leakage and
resulting damages.
• Always replace both batteries and dispose
of exhausted batteries environmentally
responsible.
• Clean battery and appliance contacts before
inserting the batteries.
• Remove the batteries from the remote
control before longer periods of non-use.
• Do not expose batteries to extreme
conditions, such as placing the remote
control on a radiator; risk of leakage.
• Avoid skin, eye and mucous membrane
contact with leaked battery acid. Wash
thoroughly and contact a physician if you
came into contact.

3. PREPARATION

3.1 SCOPE OF DELIVERY

Check the box content to ensure that all parts
were included:
• TV set with foot
• Mains power cable
• Remote control (incl. 2 batteries type LR03/
AAA .5V)
• User manual and warranty card

3.2 INSERT BATTERIES

You need to insert two batteries type LR03/
AAA, .5V.
. Open the battery compartment at the rear of
the remote control.
2. Insert the supplied batteries.
IMPORTANT! Observe correct polarity (+/-).
3. Close the battery compartment again.
6

3.3 INSTALLATION

• Remove the protective foil from the remote
control.
• Place the TV set on a stable, flat and sturdy
surface.
• Do not expose the appliance to extreme heat
or humidity.
• Ensure adequate ventilation on all sides.
If placed in a bookshelf leave minimum
distance of 20cm at top and 0cm on all
sides.

3.4 CONNECT ANTENNA

The TV set is equipped with a built-in tuner to
receive TV signals via aerial/cable connection
and DVB-T signals.
IMPORTANT! Connect the antenna before
connecting to mains power.
DVB-T Reception
CAUTION: The appliance is designed for
passive DVB-T antenna.
• Connect a DVB-T antenna to
antenna connector ANT.
Other Antenna Connections
For optimal, interference-free image quality use
a double shielded 75Ω antenna cable.
1. Connect a 75Ω antenna cable to your aerial.
2. Connect the other end to antenna connector
ANT. at the rear of the TV set.
3. Select TV in the SOURCE menu.
PLEASE NOTE: To receive programs first
execute channel search (see "Initial Installation"
on page 5).

3.5 MAINS POWER CONNECTION

The TV set is designed for AC 00-240V~
50/60 Hz.
• Connect the power cord to AC-INPUT and a
wall outlet.
CAUTION: First connect all other devices
before connecting to mains power. The wall
outlet must be freely accessible at all times.

3.6 INITIAL INSTALLATION

A window is displayed after turning the TV set
on; here you select the menu language and
start automatic search.