Before Installation; Scope Of Delivery; Assemble Device; Connect Antenna Cable - AEG CTV 2601 LCD/DVB-T Bedienungsanleitung

ENGLISH
54
CAUTION:
• Do not use odd battery types or fresh and exhausted batteries.
• Do not dispose of batteries with the household trash. Return exhausted batteries to collection points or your dealer.
NOTE:
• If the remote control range shortens the batteries are exhausted and must be replaced.
• Do not use rechargeable batteries.
• Protect batteries from heat and direct sunlight. Do not dispose of batteries by burning, danger of explosion!
• Remove exhausted batteries from the device. Remove the batteries during longer periods of non-use to avoid bat-
tery leakage.
• Wash thoroughly after coming into contact with battery acid.

4. Before Installation

4.1 Scope of Delivery

After unpacking ensure that the following parts were included:
• TV set
• Stand and four Phillips screws
• Remote control (incl. 2 x 1.5V batteries type LR03 AAA)
• User manual

4.2 Assemble Device

• Attach the stand with the four Phillips screws.
• Remove the protective film from remote control and TV set, if attached.
• Place the TV set on a stable, level surface. Ensure that the surface can carry the TV's weight.
• Protect the device from extreme heat and humidity.
• Ensure sufficient ventilation on all sides. When placed in a wall unit leave at least 20cm on top and 10cm distance at
the sides for ventilation.

4.3 Connect Antenna Cable

The TV set festures a tuner to receive TV signals via antenna/cable and DVB-T signals.
CAUTION:
• Connect the antenna cable before connecting to mains power supply.
• DVB-T reception: The device is intended for reception via passive DVB-T antenna.
• Connect the DVB-T antenna to RF INPUT input.
• In the source menu (press SOURCE button) select DTV.
Other Antenna Connections
For optimum trouble-free picture quality use a dual shielded 75 ohm antenna cable.
1. Connect a 75 ohm antenna cable to the antenna wall outlet.
2. Connect the other end to antenna input RF INPUT at the rear of the device.
3. In the source menu (press SOURCE button) select ATV.
NOTE:
To be able to watch TV you first have to search for channels ( see "4.5 Initial Installation" on page 55).

4.4 Power Connection

The TV set is designed for AC 100-240V~ 50/60Hz.
• Connect to a properly installed wall outlet.
CAUTION:
Connect all devices before connecting the TV set to mains power supply. The wall outlet must be freely accessible at all
times.