hints
●
Use fresh ingredients
●
Don't cut food too small. Fill the width of the large feed tube
fairly full. This prevents the food from slipping sideways during
processing. Alternatively use the small feed tube.
●
When using the chipper disc, place ingredients horizontally.
●
When slicing or shredding: food placed upright
shorter than food placed horizontally
●
There will always be a small amount of waste on the plate or in
the bowl after processing.
m u
lt i
p ro
citrus press
Use the citrus press to squeeze
the juice from citrus fruits (eg
oranges, lemons, limes and
grapefruits).
cone
sieve
to use the citrus
press
1 Fit the drive shaft and bowl
onto the power unit.
2 Fit the sieve into the bowl -
ensuring the sieve handle is
locked into position directly over
the bowl handle
.
3 Place the cone over the drive
shaft turning until it drops all the way down
4 Cut the fruit in half. Then switch on and press the fruit onto the
cone.
●
The citrus press will not operate if the sieve is not
locked correctly.
comes out
.
m u
lt i
p ro
m u
lt i
p r
o
.
mill
Use the mill for milling herbs, nuts and
coffee beans.
blade unit
sealing ring
jar
sprinkler lid
safety
●
Never fit the blade unit to your machine
without the jar fitted.
●
Never unscrew the jar while the mill is fitted to
your machine.
●
Don't touch the sharp blades. Keep the
blade unit away from children.
●
Never remove the mill until the blades have
completely stopped.
●
Note: The mill base is not
interchangeable with the FP920/FP930
glass liquidiser jug. The processor will
not operate if the wrong base is fitted.
Refer to graphics on blade unit bases.
important
●
To ensure long life of your mill, never run for
longer than 30 seconds. Switch off as soon as
you've got the right consistency.
●
Don't process spices - they may damage the plastic.
●
The machine won't work if the mill is fitted incorrectly.
●
Use for dry ingredients only.
to use your mill
1 Put your ingredients into the jar. Fill
it no more than half full.
2 Fit the sealing ring into the blade
unit.
3 Turn the blade unit upside down.
Lower it into the jar, blades down.
4 Screw the blade unit onto the jar
until it is finger tight.
5 Place the mill onto the power unit
and turn to lock
.
6 Switch on to maximum speed or
use the pulse control.
7 After milling, you can replace the blade unit with the sprinkler lid
and shake out your food.
●
The sprinkler lid is not airtight.
hints
●
Herbs are best milled when clean and dry.
6
m u
lt i
p ro