AEG FAVORIT 55420 Benutzerinformation Seite 40

40
Problem
Dry water drop
stains on glasses
and dishes.
The dishes are wet.
The dishes are wet
and matt.
Activating the rinse aid
dispenser with the multitab
function activated
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
3. Turn the programme knob until the
display shows two horizontal status
bars.
4. Press and hold Multitab and Delay at
the same time until the indicators
, and
5. Press Delay.
• The indicators
• The indicator
• The display shows the setting of the
rinse aid dispenser.
Possible cause
The quantity of detergent
was too much.
The released quantity of
rinse aid was not sufficient .
The quality of the detergent
can be the cause.
• The programme had no
drying phase.
• The programme had a
low temperature drying
phase.
The rinse aid dispenser is
empty.
The quality of the rinse aid
can be the cause.
The quality of the combi
detergent tablets can be
the cause.
flash.
and go off.
continues to flash.
Possible solution
Make sure that you add the
correct quantity of detergent
in the dispenser before you
start a programme.
Increase the released quanti-
ty of rinse aid.
Try a different brand of de-
tergent.
For better drying results,
keep the door ajar for some
minutes.
Make sure that there is rinse
aid in the rinse aid dispenser.
Try a different brand of rinse
aid.
• Try a different brand of
combi detergent tablets.
• Activate the rinse aid dis-
penser and use the rinse
aid together with the com-
bi detergent tablets.
6. Press Delay again and again to
change the setting.
7. Deactivate the appliance to confirm.
,
Off
On