After You Have Finished Using Your Appliance; Working With The Continuous Shredder - Silvercrest SKM 550 B1 Bedienungsanleitung

After you have finished
GB
using your appliance
IE
1) Switch the appliance off using the rotary
switch .
2) Set the rotary switch
this position until the drive unit
standstill (Image B).
3) Remove the lid.
4) Press down the release button
the pivot arm
5) Remove the attachment you have been using
from the drive unit
6) Remove the mixing bowl
7) Clean the appliance (see section "Cleaning
and care").
Working with
the continuous shredder
WARNING! RISK OF INJURY!
► To avoid personal injury and damage to the
appliance, never insert or place your hands
or any foreign objects into the feed tube.
► Always use the pusher and no other implement
or body part to push ingredients into the
appliance. Danger of injury due to rotating
parts!
► Switch from one accessory to another only
when the drive unit
still! After being switched off, the drive unit
will continue to run for a short time.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
NOTE
► The appliance may only be used when the
drive hubs not being utilised are fitted with
their protective covers.
► Make sure that neither the kneading hooks
the whisk
to the pivot arm
8
to P and hold it in
comes to a
and move
into operating position 4.
.
.
is at a complete stand-
, or the beater are attached
.
Proceed as follows to prepare the appliance for
operation using the continuous shredder
1) Press down the release button
the pivot arm
(see the section "Operating positions").
2) Set the mixing bowl
of the mixing bowl
cesses on the appliance.
3) Press down the release button
the pivot arm
4) Remove the protective cover from the drive
for the continuous shredder (Image C).
5) Insert the continuous shredder
hub socket (aligning the marking " " on the
continuous shredder
on the pivoting arm
Turn it in an anti-clockwise direction until the
continuous shredder
(and the marking " " on the continuous shred-
der is aligned with the marking "
the pivoting arm
6) Set the drive shaft
7) Depending on the task you want to perform,
place the cutting
disc onto the drive shaft
shredder .
8) Place the lid with the pusher
tinuous shredder
on the lid is lined up with the marking " "
on the continuous shredder
lid in (marking "
up with the marking " " on the continuous
shredder ).
9) Turn the rotary switch
NOTE
► Do not press too much food into the continuous
shredder . Take note of the table in the sec-
tion "Recommended filling levels".
10) Add the ingredients through the opening in the
,
lid with the help of the pusher.
:
and move
into operating position 4
into place. The base
must click into the re-
and move
into operating position 1.
into the
with the marking "
).
clicks firmly in place
" on
).
into place.
, shredding or grating
of the continous
onto the con-
(so that the marking "
) and lock the
" on the lid is lined
to the required setting.
SKM 550 B1
"
"