After You Have Finished Using Your Appliance - Silvercrest SKV 1200 A1 Bedienungsanleitung

3) To use the lid , place it on the part of the
housing which surrounds the attachment tool
socket in such a way that the filling opening
is facing you. On the attachment tool socket
there is a locking device for the lid
ATTENTION! PROPERTY DAMAGE!
► Never apply any pressure to the lid
attaching and removing it in order to ensure
that it is not damaged.
4) Depending on what you want to do, fit the
kneading hook
the attachment tool socket
–
Insert the kneading hook
beater into the socket
metal pins on the axle of the attachment
lock into the recesses of the attach-
ment tool socket
–
Press the attachment
will go into the socket
anticlockwise as far as it will go (in the
direction of the arrow
–
Let go of the attachment
firmly held in the attachment tool socket
5) Add the ingredients you wish to process into
the mixing bowl
SKV 1200 A1
:
when
, whisk or beater
:
, whisk
so that the two
.
as far as it
and then turn it
).
. This is now
.
NOTE
► Please note that during the kneading or stirring
process, the dough in the mixing bowl
increases in volume or is pressed upward
slightly as a result of the movement. You
should therefore never fill the mixing bowl
right up to the top!
Warning! Danger of crushing! Make sure
that no parts of the body are located
under the swivel arm
downwards.
6) Press down the release lever
swivel arm
downwards into the working position until the
swivel arm
NOTE
► If you wish, you can open the filling opening
on the lid
ingredients during operation.
7) Turn the rotary switch
(see the section "Speed settings").
After you have finished using your
into
appliance
1) Turn the appliance off using the rotary switch
or
(Position "0").
2) Press down the release lever
swivel arm
3) Remove the attachment
socket
lightly against the socket
clockwise at the same time (in the direction
of the arrow
attachment
4) If fitted: remove the lid
.
5) Remove the mixing bowl
clockwise and then pulling it upwards.
6) Clean the appliance (see section "Cleaning
and care").
when you push it
with the attachment mounted
locks in place.
so that you can also fill in
to the required level
to the highest position.
by pressing the attachment
and turning it
). Then you can remove the
.
.
by turning it anti-
GB │ CY
and press the
and move the
from the
7 ■
│