Trouble Shooting Esc Brushless; Troubleshooting - Carson Virus 4.0 Brushless Betriebsanleitung

Trouble Shooting ESC Brushless

Problem
After power on, motor doesn't work
After power on, motor doesn't work, but
G
emits "beep-beep-, beep-beep-" alert
tones
(Every group of "beep-beep-" has a time
interval of 1 second)
After power on, red LED always lights, the
motor doesn't work
The motor runs in the opposite direction
when it is accelerated
The motor suddenly stops running
When accelerating quickly, the motor
stops or trembles
Trouble Shooting
Problem
Model doesn´t move
Loss of control
Doesn´t run straight
Doesn´t stop
Doesn´t reverse
Running too slowly
34 CARSON Virus 4.0 Brushless 500409050 / 500409051
500409050-51_VIRUS4_Brushless_L3.indd 34
Cause
The connections between battery pack and
ESC are not correct
Input voltage is abnormal, too high or too
low
Throttle signal is abnormal
The wire connections between ESC and the
motor are not correct
The throttle signal is lost
The ESC has entered the "Low voltage protec-
tion mode" or "Over-heat protection mode"
The battery has a bad discharge performance Use a better battery
The "Start mode (Punch)" of the ESC is too
aggressive
Cause
Transmitter or chassis power switch is not
"ON"
Polarity or battery type is wrong
Batteries have run down
Batteries have run down
Antenna is missing or not attached properly
R/C model using same band (frequency) is
nearby
Steering trim is not adjusted correctly
Front and rear wheel nuts are too lose
Throttle trim is not adjusted correctly
Throttle trim is not adjusted correctly
Wrong action
Batteries have run down
Motor has lost power
Rear wheel nuts are too loose
Dust or foreign objects are inside gears
Correction
Check the power connections Replace the
connectors
Überprüfen Sie die Einstellung für die Batte-
Check the adjustment of the voltage of the
battery pack
Plug the receiver wire into the throttle chan-
nel of the receiver correctly
Swap any two wire connections between the
ESC and the motor
Check the transmitter and the receiver
Red LED flashing means "Low voltage protec-
tion". Please replace battery pack.
Green LED flashing means "Over-heat protec-
tion", please stop running to cool the ESC.
Select a softer option for the "Start mode
(Punch)"
Correction
Switch power on receiver or transmitter
Check polarity and type of battery
Change batteries or charge them
Change batteries or charge them
Attach receiver antenna and/or transmitter
antenna screw tight
Run model in different area or change crystal
Make adjustment
Tighten wheel nuts
Make adjustment
Make adjustment
Control properly
Change batteries or charge them
Change to spare motor
Tighten wheel nuts
Turn the power switch "OFF" and clean out
gears
17.02.14 09:21