Technical Data Motor And Esc; Connection/Cabeling - Carson FY8 destroyer line Betriebsanleitung

g. Technical Data Motor and ESC
Technical data motor:
Motor
U/min
GB
U/min @ 14.8 V
Short term
Dimensions (A- Ø x L)
Technical data ESC:
Forward
Reverse
Input voltage
h. Connection/Cabling
Connect the ESC, motor, receiver,
battery and servo according to the following
diagram.
Positive (+) and negative (-) wires of the ESC are connected with the
battery pack.
A, B and C are connected with the motor wires. The control cable of
the ESC (wires in black, red and white colour) is connected with the
throttle channel of the receiver (usually CH2).
If there are 2 battery packs, which need to be
connected in series, please refer to the
following picture.
Red wire to the positive
of the ESC
24 CARSON FY8 Brushless 50 040 9091
Brushless
Sensorless
2230 UpV
33 000
72 A
35.8 x 65 mm
Brushless
yes
yes
2 - 4 LiPo-cells/6 - 12 NimH cells
The A, B, C wires of the ESC can be connected with the motor wires
freely (without any order).
If the motor runs in the opposite direction, please swap any two wire
connections.
Red wire +
Black wire –
Black wire –
Black wire to the negative
of the ESC
+
Red power wire
(battery
positive)
-
Black power
wire (battery
negative)