Technical Data Motor And Esc; Connection/Cabling - Carson Virus 4.0 Brushless Betriebsanleitung

Technical Data Motor and ESC

Brushless Motor:
Motor
G
U/min
U/min @ 14,8 V
Short term
Dimensions (A- Ø x L)
Brushless ESC:
Forward
Reverse
Input voltage
4S – Connection/Cabling
Connect the ESC, motor, receiver, battery and
servo according to the following diagram.
Positive (+) and negative (-) wires of the ESC are connected with the
battery pack.
A, B and C are connected with the motor wires. The control cable of
the ESC (wires in black, red and white colour) is connected with the
Motor
Red wire to the positive of the ESC
Black wire to the
negative of the ESC
28 CARSON Virus 4.0 Brushless 500409050 / 500409051
500409050-51_VIRUS4_Brushless_L3.indd 28
DRAGSTER 4S
Sensorless
1980 UpV
29.304
80 A
36 mm Ø x 66 mm L
yes
yes
2-4 LiPo-cells
throttle channel of the receiver (usually CH2).
The A, B, C wires of the ESC can be connected with the motor wires
freely (without any order).
If the motor runs in the opposite direction, please swap any two wire
connections.
Receiver
Speedcontroller
7,4 V
Lipo
7,4 V
Lipo
17.02.14 09:21