Lighting The Burners; Safety Instructions; Lighting The Main Burners; Lighting The Side Burner - Barbecook SPRING 200 Bedienungsanleitung

9

LIGHTING THE BURNERS

To light the burners with the electrical igniter, you have to install
an AA battery in the igniter. That battery is not supplied with the
appliance. You find the battery case of the igniter on the control
panel of your appliance.

9.1 Safety instructions

• Before you light the appliance, execute all checks listed in "8
Getting the appliance ready for use".
• Make sure the lid is always open when you light a burner.
• Never bend directly over a burner when lighting it.

9.2 Lighting the main burners

9.2.1 USING THE IGNITER
1. Open the lid and set the control knobs of the main burners to
OFF.
2. 2 If no other burner is lit yet, open the gas supply and wait ten
seconds. This allows the gas to stabilize.
3. Press the igniter until you hear sparks.
4. While holding the igniter, set the control knob of the middle
burner to HIGH. Always light the middle burner first, never try to
lit all main burners at the same time.
5. If the burner does not light after three attempts, set its control
knob to OFF, close the gas supply and wait 5 minutes. This
allows any accumulated gas to escape.
6. Retry lighting the burner. If it still does not light, try lighting it with
a match or refer to "14 Troubleshooting" to determine the cause
of the problem.
7. Once one burner is lit, light the other burners by setting their
control knobs to HIGH.
9.2.2 USING A MATCH
1. Place a match in the match holder.
2. Open the lid and set the control knobs of the main burners to OFF.
3. If no other burner is lit yet, open the gas supply and wait ten
seconds. This allows the gas to stabilize.
4. Light the match and hold it about 13 mm from the burner.
10
5. Set the control knob of one burner to HIGH.
Always light one main burner to start with. Never light all main
burners at the same time.
6. If the burner does not light within 5 seconds, set its control
7. Retry lighting the burner. If it still does not light, refer to "14
Troubleshooting" to determine the cause of the problem.
8. Once one burner is lit, light the other burners by setting their
control knobs to HIGH.

9.3 Lighting the side burner

This information does not apply to the Spring 200 & Spring 300. That
appliance is not equipped with a side burner.
The side burner can only carry vessels with a maximum weight
of 9 kg and a maximum diameter of 220 mm.
9.3.1 USING THE IGNITER
1. Open the lid and set the control knob of the side burner to OFF.
2. If no other burner is lit yet, open the gas supply and wait ten
seconds. This allows the gas to stabilize.
3. Press the igniter until you hear sparks.
4. While holding the igniter, set the control knob of the side burner
to HIGH.
5. If the burner does not light after three attempts, set its control
knob to OFF, close the gas supply and wait 5 minutes. This
allows any accumulated gas to escape.
6. Retry lighting the side burner. If it still does not light, try lighting
it with a match or refer to "14 Troubleshooting" to determine the
cause of the problem.
9.3.2 USING A MATCH
1. Place a match in the match holder.
2. Open the lid and set the control knob of the side burner to OFF.
3. If no other burner is lit yet, open the gas supply and wait ten
seconds. This allows the gas to stabilize.
4. Light the match and hold it about 13 mm from the side burner.
www.barbecook.com