Illustrierter.leitfaden - Hecht 972 Originalbetriebsanleitung

IllustrIerter leItfaDen
1
ON
(4)Colding starting
2
Please operate according to the following
procedures:
a.Press oil cup until gasoline into oil cup,see
Fig.6.
b.Put the switch on the starting position,see
Fig.8.
c.Put the choker on the full position,see Fig.7.
d.Pull the starter for a few times and have it
returned slowly.Do not leave the handle to return
freely to avoid the damage of the starter.
4
Fig 6
OFF
Fig 5
a
a
e.Close the choker and pull starter h
until the engine fires.
f.After starting the engine,open choker
g.Let the engine run at low speed f
minutes,then start the spraying or d
operation.
3
a
(5)Starting the warm engine
a.Leave the choker fully open.
b.If the engine draws in too much fuel
5
the fuel switch fully close,pull the star
times.Then start the engine as above.
(6)Stopping the engine
a.Put the two control handles to their
positions and the engine stops.
b.Spray over, turn off the chemical swi
then stop the machine.
c.Having finished working, turn off t
switch. Pay attention!
Note: While the engine is running, th
must be mounted to the machine, oth
cooling air will be reduced and th
damage the engine.
Fig 8
a
DE
5 / 28