General Information About Homematic; General Information About Radio Operation - HomeMatic HM-WDS100-C6-O Bedienungsanleitung

It must be operated with 3 LR6 (Mignon/AA) batteries: no other voltage source may
be used.
Using the sensor for any other purpose does not fall within the scope of intended
use, may lead to erroneous measurement results, and shall invalidate any warranty
or liability. This also applies to any conversion or modification work.
4

General information about HomeMatic

This device is part of the HomeMatic home control system and works with the bi-
directional BidCoS® wireless protocol. All devices are delivered in a standard confi-
guration. The functionality of the device can also be configured with a programming
device and software.
The additional functions that can be made available in this way and the supplemen-
tary functions provided by the HomeMatic system when it is combined with other
components are described in the separate Configuration Instructions and in the
HomeMatic System Manual.
All current technical documents and updates are provided at www.HomeMatic.com.
5

General information about radio operation

Radio transmission is performed on a non-exclusive transmission path, which me-
ans that there is a possibility of interference occurring.
Interference can be caused by switching operations, electrical motors or defective
electrical devices.
The range of transmission within buildings can deviate greatly from open air
distances. Besides the transmitting power and the reception characteristics
of the receiver, environmental influences such as humidity in the vicinity and
local structures also play an important role.
eQ-3 Entwicklung GmbH hereby declares that this device conforms with the essenti-
al requirements and other relevant regulations of Directive 1999/5/EC.
The full declaration of conformity is provided under www.HomeMatic.com.
Notes on rectifying malfunctions
• No reception – The distance between the transmitter and receiver is too
long.
Reduce the distance between the transmitter and the receiver.
• No reception – Materials with good shielding properties are located between
the transmitter and the receiver (thick walls, reinforced concrete, etc.).
Find another position for the transmitter or the receiver. Refer also to the
"General information about radio operation" section.
• No reception – Transmitter batteries are empty.
Replace the batteries.
• No reception – The transmitter is subject to a source of interference.
(Wireless device, radio headphones/loudspeaker)
15