Electronic Control - Gram ks 400 Bedienungsanleitung

GB
All earthing requirements stipulated by the
local electricity authority must be obser-
ved. The appliance plug and wall socket
should then give correct earthing. If in
doubt, approach your local supplier or aut-
horised electrician.
WARNING
The flexible cord fitted to this appliance
has three cores for use with a 3-pin 13-
amp or 3-pin 15-amp plug. If a B.S. 1363
(13-amp) fused plug is used, it should be
fitted with a 13-amp fuse.
IMPORTANT
The wires in this mains lead are coloured
in accordance with the following code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
The colours of the wires in the mains lead
of this appliance might not correspond with
the colour marking identifying the termi-
nals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW wire
to the plug terminal marked "E" or by an
earth symbol, or coloured GREEN or
GREEN-AND-YELLOW. Connect the
BLUE wire to the plug terminal marked "N"
or coloured BLACK. Connect the BROWN
wire to the plug terminal marked "L" or col-
oured RED.
You can change the
door from righthand to
lefthand - hinged or
vice versa yourself
3
Illustration shows how easy it is to
change the door from righthand to left-
hand-hinged - or vice versa.
Lay the cabinet on its back with door
uppermost.
Take off the door handle
nary screwdriver.
To take off the door, remove the screws
with a key.
When the door is removed, one hinge rem-
ains attached to the door. This hinge must
be removed before the door is refitted.
Move the hinge pin
de. Note that the pin must be fitted "oppo-
site hand", i.e. it must be turned 1/4 of a
turn. It might be necessary to use pliers to
draw the pin out from the top.
Move the dummy hinge
side.
Place the door and fit the accompanying
hinge in place of the dummy hinge.
When refitting the door, a 9 mm packer
(wood or similar material) should be inser-
ted at the lower hinge, between the front of
the cabinet and the door edge, to create
sufficient clearance for the sealing strip.
Remember to place the correct number of
washers beneath the lower hinge to ensu-
re that the door is at the correct height.
Refit the door handle.
Starting up
If during transport the refrigerator has
been laid down, or if it has been stored in
cold surroundings (colder than +5°C) it
must be allowed to stabilise for at least 1
hour before switching on.
Start the refrigerator by plugging the lead
into a wall socket.
When the refrigerator is connected an
alarm will indicate that it is too warm and
that there has just been a power failure.
See "Alarm" for instruction on switching off
the alarm.

Electronic control

Illustration 4 shows the electronic opera-
ting panel.
Electronically controlled refrigerators are
1
using an ordi-
3 to the opposite si-
4
to the opposite
37
2