Denon AVR-1603 Bedienungsanleitung Seite 19

2 Select the Dolby Surround Pro Logic II mode.
(Main unit) (Remote control unit)
• The Dolby Pro Logic indicator lights.
Display Light
3
Play a program source with the
mark.
• For operating instructions, refer to the manuals
of the respective components.
4 Select the surround parameter mode.
Display
MODE cinema
(Main unit) (Remote control unit)
To perform this operation from the remote
control unit, check that the mode selector
switch is set to "AUDIO".
5 Select the optimum mode for the source.
(Main unit) (Remote control unit)
MODE emulation MODE cinema MODE music
or or
6 Set the surround parameters according to the
mode.
(Main unit) (Remote control unit)
• The mode switches as shown below each
time the button is pressed.
MODE EMULATION MODE CINEMA MODE MUSIC
CINEMA EQ CINEMA EQ PANORAMA
DEFAULT DEFAULT DIMENSION
CENTER WIDTH
DEFAULT
7 Set the various surround parameters.
• CINEMA EQ setting
CINEMA EQ OFF
OFF ON
or or
• PANORAMA setting
PANORAMA OFF
OFF ON
or or
• DIMENSION setting
DIMENSION 3
0 3 6
or or
• CENTER WIDTH setting
CENTER WIDTH O
0 4 7
or or
• DEFAULT setting
DEFAULT Y/N
YES Y/N NO
or or
Select "Yes" to reset to the factory defaults.
8 Press the ENTER button to finish surround
parameter mode.
(Remote control unit)
NOTE:
• When making parameter settings, the display will
return to the regular condition several seconds
after the last button was pressed and the setting
will be completed.
Surround parameters q
Pro Logic II Mode:
The Cinema mode is for use with stereo television shows and all programs encoded in Dolby Surround.
The Music mode is recommended as the standard mode for autosound music systems (no video), and is
optional for A/V systems.
The Emulation mode offers the same robust surround processing as original Pro Logic in case the source
contents is not of optimum quality.
Select one of the modes ("Cinema", "Music" or "Emulation").
Panorama Control:
This mode extends the front stereo image to include the surround speakers for an exciting "wraparound"
effect with side wall imaging.
Select "OFF" or "ON".
Dimension Control:
This control gradually adjust the soundfield either towards the front or towards the rear.
The control can be set in 7 steps from 0 to 6.
Center Width Control:
This control adjust the center image so it may be heard only from the center speaker; only from the left/right
speakers as a phontom image; or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
Dolby Digital mode (only with digital input) and DTS Surround (only with digital input)
1
Select the input source.
Playback with a digital input
q Select an input source set to digital (COAXIAL/
OPTICAL) (see page 12).
Example:
(Main unit) (Remote control unit)
w Set the input mode to "AUTO" or "DTS".
(Main unit) (Remote control unit)
2 Select the Dolby/DTS Surround mode.
(Main unit) (Remote control unit)
3
Play a program source with the ,
mark.
• The Dolby Digital indicator
DIGITAL
lights when playing Dolby
Light
Digital sources.
• The DTS indicator lights when
Light
playing DTS sources.
ENGLISH
1 1 3
2
2
1
4, 5, 6, 7, 8
9
5, 6, 7, 8 5, 6, 7, 8
5, 6, 7, 8
1
19