Denon AVR-1603 Bedienungsanleitung Seite 22

ENGLISH
(3) DELAY TIME
Use the
(Remote control unit)
(4) D. COMP.
Use the
(Remote control unit)
NOTE: This parameter is displayed during DOLBY DIGITAL playback.
(5) LFE
Use the
(Remote control unit)
NOTE: This parameter is displayed during DOLBY DIGITAL and DTS playback.
(6) DEFAULT
To reset the settings to the factory defaults, use the
buttons to display "Yes".
(Remote control unit) DEFAULT
4 Press the ENTER button to finish surround parameter mode.
(Remote control unit)
22
(left) and (right) buttons to set the delay time.
(Initial)
0ms 30ms 110ms
DELAY 30ms
(left) button (right) button
(left) and (right) buttons to set the D. COMP.
(Initial)
OFF LOW MID
D.COMP. OFF
(left) button
(left) and (right) buttons to set the LFE level.
(Initial)
-10dB 0dB
LFE 0dB
(left) button (right) button
YES Y/N NO
Y/N
(left) button (right) button
• Operating the surround mode and surround parameters from the main unit's panel.
1 Turn the SELECT knob to select the surround
mode.
• When turned clockwise
DIRECT
HI
VIRTUAL SURROUND
• When turned counterclockwise
DIRECT
(right) button
VIRTUAL SURROUND
To select the surround mode while adjusting the surround parameters, channel volume or tone control,
press the SURROUND MODE button then operate the selector.
2
Press the SURROUND PARAMETER button.
Press and hold in the surround parameter button to select the parameter you want to set.
• The parameters which can be set differ for the different surround modes. (Refer to "Surround Modes and
Parameters" on page 23.)
(left) and (right)
3
Display the parameter you want to adjust, then turn the SELECT knob to set it.
NOTE:
• When playing PCM digital signals or analog signals in the 5CH STEREO, ROCK ARENA, JAZZ CLUB, VIDEO
GAME, MONO MOVIE or MATRIX surround modes and the input signal switches to a digital signal encoded
in Dolby Digital, the Dolby surround mode switches automatically. When the input signal switches to a DTS
signal, the mode automatically switches to DTS surround.
Surround parameters e
ROOM SIZE:
This sets the size of the sound field.
There are five settings: "small", "med.s" (medium-small), "medium", "med.l" (medium-large) and "large".
"small" recreates a small sound field, "large" a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15.
DELAY TIME:
In the matrix mode only, the delay time can be set within the range of 0 to 110 ms.
(Main unit)
STEREO DOLBY PRO LOGIC II 5CH STEREO
MATRIX VIDEO GAME JAZZ CLUB
STEREO DOLBY PRO LOGIC II
5CH STEREO
MATRIX VIDEO GAME JAZZ CLUB
(Main unit)
(Main unit)
1 2 1, 3
MONO MOVIE
ROCK ARENA
MONO MOVIE
ROCK ARENA