Surround - Denon AVR-1603 Bedienungsanleitung

ENGLISH
Recording the program source (recording the source currently being monitored)
1 Follow step 1 to 3 under "Playing the input source".
Simultaneous recording
The signals of the source selected with the function selector button are output simultaneously to the
CDR/TAPE and VCR AUDIO OUT jacks. If a total of two tape and/or video decks are connected and set to
the recording mode, the same source can be recorded simultaneously on every decks.
NOTES:
• The AUDIO IN's signal selected with the function selector button are output to the CDR/TAPE and VCR
AUDIO OUT jacks.
• The DIGITAL IN's signal selected with the function selector button are output to the DIGITAL OUT (OPTICAL)
jack.

13 SURROUND

Before playing with the surround function
• Before playing with the surround function, be sure to use the test tones to adjust the playback level from each
speakers. This adjustment can be performed from the remote control unit, as (described) below.
• The adjustment with the test tones is only effective in the DOLBY/DTS SURROUND modes.
The adjusted playback levels for the different surround modes are automatically stored in the memory of each
surround modes.
1 Set the DOLBY/DTS SURROUND (Dolby Pro
Logic II or Dolby Digital or DTS) modes.
(Main unit) (Remote control unit)
2
Press the TEST TONE button.
Test tones are output from the
different speakers. Use the
channel volume adjust buttons
to adjust so that the volume of
the test tones is the same for
all the speakers.
NOTE: Please make sure the "AUDIO" position
of the slide switch on the remote control
unit.
3 After completing the adjustment, press the
TEST TONE button again.
(Remote control unit)
18
2 Start recording on the tape or video deck.
For instructions, refer to the component's operating
instructions.
1
1
(Remote control unit)
(Remote control unit)
2, 3
• After adjusting using the test tones, adjust the channel levels either according to the playback sources or to
suit your tastes, as (described) below.
1 Select the speaker whose level you want to
adjust.
(Main unit)
The channel switches as shown below each time
the button is pressed.
FL CNTR
NOTE: Please make sure the "AUDIO" position
of the slide switch on the remote control
unit.
2 Adjust the level of the selected speaker.
(Main unit)
Only adjustable when
the channel is
selected with the CH
VOL buttons on the
main unit.
Dolby Surround Pro Logic
1 2
1 Select the function to which the component you
want to play is connected.
Example:
2
(Main unit)
2
(Remote control unit)
FR SR SL
SW
1
Default setting of channel level is 0 dB.
The level of the selected speaker can be adjusted
within the range of +12 to –12 dB.
SW channel level can be turned off by decreasing
(Remote control unit)
one step from -12 dB.
OFF ´ -12 dB ´ 12 dB
II mode
2
1
4, 6 5, 7
8
5, 7
(Remote control unit)
2 1
2
2
The Dolby Surround Pro
Logic II Cinema or Music
mode can be chosen
directly by pressing the
CINEMA or MUSIC
button on the remote
control unit during
playback in the Dolby
Surround Pro Logic II
mode.
4, 6
5, 7