Litecraft PAR 64 AT10 Bedienungsanleitung Seite 9

• Make sure that the cable has never been squeezed or damaged by
sharp objects. Check the device and the cables regularly.
• If the cable is damaged, it must be replaced immediately by the
manufacturer, its service agent or a qualified person in order to avoid
danger.
• Lenses, glasses or UV filters must be replaced if they are visually
damaged, or their effectiveness is impaired, e.g. by broken glass or by
deep scratches.
• Ensure that wires never come in contact with other wires! Handle the
power cord and all connections with caution!
• Make sure that the line voltage is not higher than the voltage specified
in this manual.
• Disconnect the unit from the AC mains when it is not in use or when
cleaning it. Disconnect the connection only by pulling the cable plug.
• Using the fixture for the first time, can result in light smoke and odors.
This is a normal process and does not constitute a defect.
• RISK OF BURNS! Do not touch the unit during operation! The housing
may reach high temperatures.
• RISK TO HEALTH! Never look directly into the light source. Especially
epileptics risk an epileptic shock! Disconnect the unit from the AC
mains when not in use or when cleaning it.
• Defects caused by modifications of the device by unqualified handling
or an unqualified person are not covered by the warranty.
• Keep the product away from children and unskilled people.
• There are no wear parts in the device. Maintenance and service must
be performed only by an authorized service partner.
ADVICE!
This product is equipped with a new yoke and a revised design of the
brake. Hereby the positioning is improved. Therefore it is absolutely
essential to fasten the brake only hand-tight and without use of tooling.
Before re-positioning the fixture the brake needs to be released!
Disregarding can cause defects of the fixture.
Defects, followed by modifications of the fixture, inproper use or by the use
of unqualified persons are not part of warranty.
II