Changing The Throttle Ratchet To The Right-Hand Stick; Connecting The Servos; Elevon Mixer - ROBBE-Futaba Skysport T4YF Bedienungsanleitung

7.3 CHANGING THE THROTTLE RATCHET TO THE RIGHT-
HAND STICK
If you change the throttle ratchet function from left to right, the
elevon mixer can no longer be used!
This is the procedure:
(stated right / left directions = as seen from the rear of the trans-
mitter)
1. Remove the transmitter battery
2. Undo the four screws in the back panel using a cross-
point screwdriver.
3. Remove the back panel.
4. Undo the throttle ratchet spring on the right-hand stick
unit, and remove it.
5. Install the throttle ratchet spring on the left-hand stick
unit.
6. Use a pair of tweezers to disconnect the spring on the
left-hand vertical centring rocker.
7. Remove the centring lever from the left-hand stick unit.
The left-hand vertical stick function is now converted to ratchet
function.
8. Install the centring lever in the right-hand stick unit,
and connect the spring using tweezers. The right-hand vertical
stick function is now converted to self-neutralising action.
Pos. 4
Remove throttle spring on Install throttle spring on left
right
8
Skysport T4YF 2,4 GHz
Pos. 6
Disconnect spring from left-
hand vertical centring rocker

8. CONNECTING THE SERVOS

The servo sequence at the receiver is fi xed. If you wish to
exploit the transmitter's integral elevon facility, you must keep to
the stated servo sequence at the receiver output sockets. The
sockets and their functions are shown in the illustration below,
and stated in the table.
The following diagram shows the servo sequence for a 'fi xed-
wing' model aircraft.
The battery is connected to the receiver socket marked 'B'.
R2004 GF
receiver
Aerial
Charge socket
Pos. 5
Switch
Receiver
Output
Channel 1
Lager
Channel 2
Feder
Wippe
Channel 3
Channel 4
Pos. 8
Install centring rocker on right-
8.1 ELEVON (DELTA) MIXER
hand stick unit. Connect spring
at bottom fi rst, then to rocker
This function is required for model aircraft of the delta or fl ying-
wing confi guration. Two servos are used to control superim-
posed ailerons / elevators, and the mixer controls the servos
in accordance with the pilot's commands. If the pilot operates
the elevator stick, both servos rotate in the same direction; if he
operates the aileron stick, they rotate in opposite directions. The
right-hand elevon servo must be connected to receiver output
2 (AIL), and the left-hand elevon to channel 1 (ELE). If either
channel needs to be reversed (to suit your particular model),
the hardware change-over switches on the front panel should
be used.
Channel 4
Rudder
Channel 3
Throttle
Channel 2
Elevator
On
Channel 1
Aileron
Off
The mixer can be switched on as described below:
1.
2.
Receiver battery R
3.
Note:
It is essential to check the system before fl ying the model!
Function
Aileron, or left elevon
if elevon mixer is activated
Elevator, or right elevon
if elevon mixer is activated
Throttle
Rudder
CH1
L
Aileron
Elevon Mischer
ON/ OFF
L
Elevator
Open the transmitter battery compartment and remove
the two battery cells on the left.
Use a small slot-head screwdriver to move the micro-
switch to the desired position (see diagram above).
Replace the battery cells and close the transmitter
battery compartment again.
CH2
R
R