Cleaning The Mixer - Silvercrest SSM 550 C1 Bedienungsanleitung

Cleaning the mixer

So that you do not injure yourself on the cut-
r
ters , clean the mixer jug
handled dishwasher brush.
In a case of stubborn soiling, the mixer jug
can also be cleaned in a dishwasher. For this,
always take the mixing jug
described later.
w
Clean the cover
dishwasher or with the normal washing up.
If you clean the liquidiser directly after use, you can
often achieve a satisfactory and hygienic level of
cleaning with the following alternative:
If you clean the liquidiser directly after use, you can
often achieve a satisfactory and hygienic level of
cleaning with the following alternative:
e
Fill the mixer jug
add a few drops of mild detergent. Close the
w
cover and fit the mixer jug
u
block .
Insert the plug into a mains power socket and
activate the Ice Crush/Clean operation a few ti-
mes, such that the cutting blade
through the water at full speed.
Afterwards, rinse the blender
clean water to ensure that all detergent residues
have been removed.
e
only with a long
e
apart, as
q
and the filling cap
with 750 ml of water and
e
onto the motor
r
ploughs
e
out with lots of
Should this not dislodge the soiling, you can separate
the lower plastic part of the mixer jug
r
ters ) from the the glass part:
e
in a
Glass element
Sealing ring
Cutting blade
Plastic element
Remove the mixer jug
u
.
Turn the plastic element
e
ment
be released from the glass element
Attention!
Take care with the cutters
Risk of injury!
Clean both parts thoroughly in a mild soapy
solution or in a dishwasher.
Replace the plastic element
back onto the glass element
sealing ring
- 38 -
e
from the motor block
of the mixer attach-
anti-clockwise, such that it allows itself to
. They are very sharp.
of the mixer jug
is correctly fitted.
e
(with the cut-
.
e
. Ensure that the