Cleaning; Cleaning The Blender - Silvercrest SSMC 600 B1 Kurzanleitung

Cleaning

DANGER! ELECTRIC SHOCK!
Before starting to clean the blender and its components:
► Ensure that the motor is switched off and the power plug removed from the
socket.
►
► Never open the housing of the appliance. Otherwise, there is a risk of a
fatal electric shock.
WARNING! RISK OF INJURY!
► Handle the cutting blades with extreme caution. They are extremely sharp!
CAUTION! PROPERTY DAMAGE!
► Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them.

Cleaning the blender

■ To prevent injuring yourself on the cutting blades, clean the blender only with a
long-handled washing-up brush.
■ Clean the measuring cap and the lid in a mild soap solution. You can
remove the rubber seal to clean the blender lid by hand. Make sure that the
rubber seal is correctly reattached before you use the lid again.
NOTE
when cleaning in the dishwasher, as it might otherwise deform. If possible,
place the plastic parts in the upper basket of the dishwasher and make sure
that they are not jammed. Otherwise, they could become misshapen or suffer
from stress cracks.
■ If you clean the blender directly after use, you can often achieve a
satisfactory and hygienic level of cleaning by doing the following:
Fill the blender attachment with 750 ml of water and add a drop of washing
up liquid. Close the lid and fit the blender attachment onto the motor unit.
Insert the mains plug into the socket and activate the pulse function a few
times so that the cutting blades plough through the water at maximum speed.
Afterwards, rinse the blender attachment with plenty of clean water to
remove any washing up liquid residues.
│ GB │ IE
■ 8
Do not immerse the motor block in water or other liquids. This could
result in you receiving a fatal electric shock and cause damage to the
appliance.
You can also clean the lid together with the rubber seal, the
measuring cap and the blender attachment in the dishwasher along
with the cutting blades. We recommend not removing the rubber seal
SSMC 600 B1