Care Advice; Cutting And Sawing Branches - FLORABEST Z31102 Bedienungsanleitung

©
Extending the telescopic handle (Figure F)
Press the two locking levers down to allow the telescopic
handle to be extended.
Extend the telescopic handle up to the desired hole.
Note: The maximum length of the combination branch cutter
is 2.65 m, the minimum length is 1.6 m.
Release the two locking levers to fix the length of the telescopic
handle. Ensure that the locking pins engage in the corresponding
holes.
©

Care advice

Clean the blades carefully after every use. Dirt and sap on the
blades lead to rust formation, obstruction of the cutting action
and plant disease.
Rub the metal parts with an oiled cloth to protect them from
the build up of rust.
Regular care carried out properly will ensure that your shears
will give you years of use.
©

Cutting and sawing branches

Do not cut branches with diameters greater than 30 mm
(see Fig. C).
Use the branch saw for thicker branches. The maximum saw
length is 300 mm (see Fig. C).
The product has a force multiplying lever-rope system. Pull on
the rope to cut the branch (see Fig. D).
8 GB/IE
30134_Content_LB3.indd 8 24.02.10 09:05