Transmitter Modes; Calibration; Flight Modes - XciteRC #15001300 Rocket 400 Bedienungsanleitung

you have approximately 1 to 2 minutes left to fly back the model or land safely. With the battery lifetime short
the blinking frequency becomes higher, meaning the LED's will blink faster– instantly land!
If the battery is empty, the motors cannot be unlocked, the model can't start. Exchange battery or recharge.
EN

Transmitter modes

Regard: To start, the switches have to be adjusted to position „normal"
SWA Mode ON/OFF
SWB Mode ON/OFF
WARNING: If the green LED blinks, all GPS-supported modes (Position-Hold, Altitude-Hold and Co-
ming-Home) mustn't be used for the model receives no sufficient GPS-signal and is unable to determine its
position – danger of falling! Also without function is the Failsafe Coming-Home!
IMPORTANT: before the first flight of the integrated magnetometer needs to be calibrated.
Proceed as follows:
• Place the Quadrocopter on a level surface and turn it on. The rear LED's flash alternately fast.
NOTE: avoid objects with large metal surfaces, eg. halls with metal cladding, so that nothing interferes
the correct calibration.
• Turn both switches SWA and SWB of the transmitter in position 0 and switch on the transmitter.
• Place the Quadrocopter on a flat surface and move the switch SWA from position 0 to 2 and back again,
until the left LED will begin to flash yellow. The Quadrocopter is in calibration mode.
• Now rotate the Quadrocopter on the flat area about 3-5 times in a circle (A) and observe the left, yellow
LED. Once it flashes slowly, rotate the model in the vertical with the face down and turn it again 3-5 times
(B). Observe again the left LED, when it flashes red, turn the Quadrocopter again on a level surface and
turn it off. The magnetometer is now calibrated ready.
• NOTE: if the left LED's flashing the next you switch alternately (red and yellow), the calibration has
failed and must be repeated.

Flight modes

Normal: Normal flight without GPS or altimeter control. If the mode is active the transmitter's red LED is on.
Position Hold: Fly to the favoured spot in a stable position and make sure the switches are adjusted cor-
24
Mode
Normal
Position Hold
Flight Direction Locked
Altitude Hold
Coming Home
A
Transmitter modes · Calibration · Flight modes
Switch SWB (left)
0
0
1
1
0
3 - 5 times
Switch SWA (right) Transmitter-LED
0
1
1
2
2
B
XciteRC Rocket 400 GPS
red
blue
green