Rc Functions; Transmitter Modes - XciteRC Rocket260 Bedienungsanleitung

• Note: when the model is not used for about 30 seconds, it automatically switches back to the bind
mode, the LEDs starts to fl ash. To fl y, the throttle must once again moved all the way up and then back
EN
in the lowest position
• GYRO CALIBRATION: before the fi rst fl ight the gyro must be calibrated. Move both control levers
downwards to the left (4) and hold until all LEDs fl ash briefl y. This is also necessary if the model fl ies badly
e.g. after a crash
• MODE SELECTION: to select the control mode 1 or 2 (see chart RC functions), switch the transmit-
ter off and press the right trim lever. Now switch on the transmitter again (5). NOTE: Mode 2 will not stored
after switching the transmitter off. Mode 2 must be re-activated each time switching the transmitter on.
• If the fl ight battery runs low, the LEDs on the motor mounts starts fl ashing. From now on the model is con-
trollable for one more minute only. Find a suitable landing spot and land. Charge the fl ight battery again.

RC functions

Mode 1 (factory setting)
20
4 5
Mode 2
RC functions
XciteRC Rocket 260 3D