Restoring The Preset Quantities; Milk Carafe; Filling The Carafe; Inserting / Removing The Carafe - Saeco Cafissimo LATTE Bedienungsanleitung

Preset quantities:
Espresso approx. 40 ml
Caffè crema approx. 125 ml
Filter coffee approx. 125 ml
This quantity can be reprogrammed according to your preference for
each beverage.
Minimum quantity that can be set: approx. 30 ml
Maximum quantity that can be set: approx. 250 ml
(filter coffee)
Maximum quantity that can be set: approx. 300 ml
(caffè crema, espresso)
The procedure for setting the quantity of espresso
example below.
Before brewing a coffee, check that the On/Off button
and beverage buttons are constantly lit and that
there is enough water in the tank.
Proceed as follows to reprogram the quantity of espresso
1- Place an espresso cup under the coffee dispensing spout,
changing the height of the spout or the position of the tray if
necessary (see section "Adjusting the dispensing height").
Insert a new capsule as described in the previous paragraph.
2- Press and hold the espresso button
flashes in brief intervals. Then release the button.
3- Press the espresso button
in the cup reaches the desired level.
At this point the espresso button
the machine will brew the same amount of coffee that was just pro-
grammed.
For the other beverages, follow the same procedure
by pressing the caffè crema
coffee (blue) buttons.

Restoring the preset quantities

To reset beverages to their factory settings, with the machine off,
press and hold the On/Off
for 5 seconds. All buttons will flash twice in confirmation.

MILK CARAFE

The machine has a carafe for brewing cappuccino, frothed milk and
other beverages containing milk.

Filling the carafe

The carafe must be cleaned before being used. Follow steps 1 to 7 as
described in the section "Weekly cleaning of the milk carafe".
is shown as an
for 3 seconds until it
again when the amount of coffee
is set. Each time it is pressed,
(yellow) or filter
and filter coffee (blue) buttons
To make a good quality cappuccino, use cold milk
(~5°C / 41°F) with a fat content of at least 1.5 %.
Fig. 1
1- Remove the carafe lid (Fig. 1).
2- Pour the milk into the carafe; the quantity should be between
the MIN and MAX levels (Fig. 2).
3- Replace the carafe lid and ensure that it is properly fitted
(Fig. 3).

Inserting / removing the carafe

:
Do not hold the carafe by the lid as it can come off.
Insert and/or remove the assembled carafe as described in the
following instructions.
Fig. 1
1- Move the carafe alongside the machine, keeping it slightly raised
(Fig. 1).
2- Attach the carafe to the machine by pushing down gently until it
clicks into place (Fig. 2).
3- To remove the carafe, lift it and carefully pull away from the
machine (Fig. 3).
CAPPUCCINO / FROTHED MILK / LATTE
MACCHIATO
Warning! Dispensing may be preceded by small jets
of hot water: danger of scalding! If the carafe is ab-
sent, products requiring milk should not be selected.

Cappuccino

Before preparing a cappuccino, check that the On/Off
button
and that there is enough water in the tank.
Fig. 2
Fig. 2
and beverage buttons are constantly lit
• 25 •
Fig. 3
Fig. 3