Descaling - Saeco Cafissimo LATTE Bedienungsanleitung

Never drink the solution dispensed during this
procedure.
5- With the machine turned on, press the frothed milk button
Wait until it has finished dispensing.
6- Empty the container and place it back under the milk dispensing
spout.
7- Repeat steps 5 to 6 until the milk carafe is empty, then proceed to
step 8.
8- Remove the carafe from the machine and wash thoroughly with
fresh water.
9- Fill the milk carafe with fresh drinking water up to the MAX level
and then place it back in the machine.
10- With the machine turned on, press the frothed milk button
Wait until it has finished dispensing.
11- Press the rinse button
pensing.
12- Empty the container and place it back under the milk dispensing
spout.
13- Repeat steps 10 to 12 until the milk carafe is empty, then proceed
to step 14.
14- Remove and wash the milk carafe as described in the section
"Weekly cleaning of the milk carafe".
The machine must not be exposed to temperatures
lower than 0°C as the water in the circuits may freeze
(even if the tank has been emptied).

DESCALING

A step-by-step video explaining the descaling process can be found
at www.tchibo.de/cafissimo-entkalkung.
The descaling process takes approx. 25 minutes and is split between
the descaling itself and a rinse cycle. Do not under any circumstance
interrupt or switch off the machine during either of these cycles.
Limescale builds up inside the machine during normal use. It needs
to be removed regularly as it may clog the water and coffee circuit of
your machine. The machine automatically indicates when it needs
descaling when the service indicator light
lit.
Not doing this may ultimately make your machine
stop working properly, and in this case repairs are NOT
covered by your warranty.
We recommend using Saeco descaling solution (sold
separately), whose formula has been designed to
respect the technical specifications of the machine, thus
ensuring its continued service in the long term and for its safe
and risk-free use. The descaling solution is to be disposed of
according to the manufacturer's instructions and/or the
regulations in force in the country of use. The Durgol descaling
solution also respects the technical specifications of the
machine.
(orange). Wait until it has finished dis-
(orange) is constantly
Warning! Never drink the descaling solution or any
products dispensed until the cycle has been com-
pleted. Never use vinegar as a descaling solution.
.
1- Turn the machine off by pressing the On/Off button
2- Check that the carafe is correctly inserted and filled with water
up to the MIN level, that there is no capsule in the compartment
and that the lever is lowered.
3- Remove and empty the water tank, drip tray and used capsule
drawer.
4- Pour the required amount of descaling solution into the water
tank and fill it with fresh water up to the MAX level.
5- Put the tank back into the machine.
.
6- Push the drip tray all the way into the machine and raise the
coffee dispensing spout.
7- Place a container with a minimum capacity of 1 litre under the
the coffee and milk dispensing spouts.
8- At the same time, press the On/Off button
cappuccino button
9- The machine indicates that the process has started when the
service indicator light
button (white) will also be constantly lit to indicate the first
phase of the descaling operation.
During descaling, the On/Off button
operate. If the power cord is removed, the machine will
continue the descaling cycle from the phase in which it was
interrupted the next time it is turned on.
10- Press the espresso button
descaling solution.
The machine dispenses the descaling solution at regular inter-
vals via the coffee dispensing spout and via the milk carafe. The
espresso button (white) flashes throughout this first phase.
The cycle can be temporarily suspended by pressing
the rinse button
the descaling process.
11- The service indicator light
descaling solution has been dispensed.
12- Empty the container into which the descaling solution was collect-
ed and reposition it under the milk and coffee dispensing spouts
after the drip tray has been emptied and replaced.
The cappuccino button
13- Empty the water tank and rinse it thoroughly. Then fill it up to the
MAX level with fresh drinking water. Place the tank back in the
machine.
14- Press the cappuccino button
The machine dispenses the rinsing water alternately via the
coffee dispensing spout and milk carafe, with the cappuccino but-
ton flashing throughout this phase.
(green) and the
(white) for 3 seconds, then release.
(orange) is constantly lit; the espresso
(green) will not
(white) to start dispensing the
. Press it again to continue with
(orange) starts to flash once all the
will light up automatically.
to start the rinse cycle.
• 31 •
.