Technical Data; Installation - IKEA FROSTIG SC136 Gebrauchsanweisungen

ENGLISH
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
the assembly instructions.

Technical data

Dimensions
Height
Width
Depth
Net Volume
Defrost System
Energy Consumption
Noise Level
Energy Class

Installation

Caution! Read the "Safety
Information" carefully for your safety
and correct operation of the appliance
before installing the appliance.
Important! Refer to the assembly
instructions for the installation.
Location
To ensure best performance, install the ap-
pliance well away from sources of heat such
as radiators, boilers, direct sunlight etc.
Make sure that air can circulate freely
around the back of the cabinet.
815 mm
596 mm
550 mm
136 Litre
auto
0,340 kWh/24h
36 dB (A)
A+
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
The technical infor-
mation are situated
in the rating plate on
the internal left side
of the appliance and
in the energy label.
Positioning
This appliance can be installed in a dry,
well ventilated indoor (garage or cellar) al-
so, but for optimum performance install this
appliance at a location where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate class
SN
N
ST
T
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
Ambient tempera-
ture
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
12