Hydraulics; Transport Directions; Warranty; Faults - Gude DHH 1050/7 T MBS Bedienungsanleitung

8. Hydraulics

Hydraulic hoses and joints shall be checked for leakage every 4 hours of operation and retightened if necessary.
Hydraulic oil/tank
Common hydraulic oil may be replenished in all cleaving machines ( HLP 46 e.g.)
or another product of the same viscosity. Oil change is not necessary .
Type DHH 1050/7 t MBS: tank ca 6 litres

9. Transport Directions

Transport
All cleaving machines have large wheels. . To move the machine, hold the cleaving column lug with one hand and the
lug above the motor with the other hand and tip the machine slightly over to your body. Once in this position, the
machine may travel easily.
Never transport the cleaving machine in horizontal position to prevent
any leakage of fuel and hydraulic oil.
For transport, move the cleaving knife down completely.
Noise Information
Type DHH 1050/7 T MBS ca 75 dbA = full load ca 90 dbA

10. Warranty

Warranty according the warranty card attached.

11. Faults

Fault
Hydraulic pump whistles and
operation of the cleaving knife is
jerky
This machine should not be used for any other works than those, which the machine is designed for and which are described
in the operation manual.
Cause
- too little hydraulic oil in the tank
6
Removal
-Replenish the hydraulic oil
GB