3
Cleaving Cross Assembly
1
3.
Fit the cleaving cross and the hold-in screw in the recess
So that the nut fits on.
4
3.
Adjust the grabs to correspond to the wood piece diameter .
4
1.
Screw the holding screw in the cross up to the half .
2
4.
Adjust the screw and the nut for the
cleaving cross to get pushed completely
up
5.
Secure the terminal position
with a screwdriver and tighten
4
4.
Secure the hold-in stud bottom with a
cotter pin included in the delivery.
2.
Screw on the nut included from
outside.
3
5
GB