Master/Slave-Operation; Connection With The Mains; Operation - EuroLite LED MF-3 RGB Flowereffekt Bedienungsanleitung

Master/Slave-Operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the LED MF-3 RGB you can find an XLR-jack and an XLR-plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the OUT-jack with the IN-plug of the next device.

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

After you connected the effect to the mains, the LED MF-3 RGB starts running.
You can do without a controller as the LED MF-3 RGB features a built-in microphone, which provides
automatic sound control.
You can adjust the operating functions with the 3-step mode-selector on the rearpanel:
International
L
N
17/34 00029941.DOC, Version 1.0