Operating The Device - Caso Eco 3400 Bedienungsanleitung

Operating the device

•
Plug the power plug into a suitable outlet. 
•
The control lamp of the ON/Standby switch lights up and the temperature of the
cooker plate surface displayed: is the temperature of the surface of the induction
cooker lower than 50°C, the display shows "-L-". When the temperature of the
cooker plate surface is over 50 °C, it is displaying "-H-".
Now the device is in standby mode.
•
Place suitable cookware in the centre of one of the cooking fields.
•
You can operate the left cooking field with 2000 W and the right cooking field with
1400 W separately.
•
Now press the ON/Standby switch 1. to turn on of the two induction hotplates on.  T he
control lamp "Stage" blinks and an acoustic signal sounds.
•
Press the Function Key 3. The preset power stage "5" is selected and the device turns on.
•
With the + / - Keys (5+6), you can change the settings at any time in a range from 1 – 10
•
Press the Function Key 2. to select the temperature. The preset temperature stage "120°C" is
selected and the device turns on.
•
With the + / - keys, you can change the settings at any time in a range from 60 – 240°C.
(Temperature stages: 60, 80, 100, 120, 140, 160, 180, 200, 220 and 240°C)
•
Timer Function.  A fter the selection of the temperature mode press the button Time 4. until
the corresponding control lamps blink. The display shows the number "0". With the arrow
keys, you can now select the operating time in 1-minute intervals (up to max. 180
minutes). Once the time is up, an acoustic signal sounds and the device automatically
goes into standby mode. Notice: during timer operation, you can change the duration at
any time with the arrow keys. With the memory function of the device, the power stage or
temperature settings remain unchanged here.
You can also change to the power stage selection or the temperature stage selection with
the "Function" button and change the settings there without changing the preset time.
•
Do not place any empty cookware on the ceramic field. Heating an empty pot or pan
activates the overheating protection and the device turns off.
•
Do not operate the device if it is damaged in any way or does not function properly. 
•
The use of accessories and spare parts not recommended by the manufacturer may lead
to damage on the device and injuries.
•
In case of "E05" appearing in the display the over heat protection has been activated.
This means that the temperature had increased to a temperature of 170°C. In this case the
device turns off automatically in order to avoid damages.
Therefore we recommend to select the function "Stufe" in case of steaming food or boiling
water for example.
In case of grilling or cooking deep fry food we would advise you to use the function
"Temperatur" as in this case you can use temperatures up to 240°C.
In case of "E05" please pull the power plug in order to reset the device. After this you can use
it again as usual.
When you switch off the device via "On/Standby" and the temperature of the cooker plate
surface is lower than 50°C, the display shows "-L-". When the temperature of the cooker
plate surface is over 50 °C, it is displaying "-H-".
A
n acoustic signal sounds.
15