Error Messages/Trouble Shooting - Torqeedo Travel 503 S Bedienungsanleitung

7.6 Error messages/trouble shooting

Display
E02
E05
E06
E07
E08
E21
E22
E23
E30
E32
E33
E41, E42
E43
E45
E46
E 48
Other error
codes
No blinking
during charge
process, no
function of tiller-
20 display during
charge process
Cause
Stator over-temperature
(motor overheating)
Motor/propeller blocked
Voltage in the motor too
low
Motor overcurrent
Circuit board overheating
Tiller calibration defective
Magnetic sensor defective
Value range false
Motor communication
error
Tiller communication error
General communication
error
Incorrect charging voltage
Battery empty
Battery overcurrent
Battery operating tempe-
rature error
Charging temperature
error
Faulty
Faulty
What to do
Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
Disconnect motor cable from battery, then loosen blockage
and turn propeller one revolution by hand. Reconnect
motor cable.
Low battery charging status. Motor can potentially be used
again slowly from the stop position.
Continue at low output.
Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
• Re-calibrate: Press "cal" button for 10 seconds.
• The display shows "cal up": Press tiller forward to full
gas then press the "cal" button.
• The display shows "cal stp": Return tiller to central posi-
tion then press the "cal" button.
• The display shows "cal dn": Press tiller backward to full
gas then press the "cal" button.
Re-calibrate (refer to E21)
Re-calibrate (refer to E21)
Check the motor cable's plug-in connection. Check the
motor cable for damage.
Check the tiller's plug-in connections. Check the cable.
Check the plug-in connections and cables. Switch the
motor off and on again.
Use a Torqeedo power supply. If the error occurs in spite
of using a Torqeedo power supply, wait untill the battery
dissipates the overcharge. Should the error persist please
contact Torqeedo Service.
Charge battery. Motor can potentially be used again slowly
from the stop position.
Switch motor off and on again. If this error occurs the
battery status indicator and range display can no longer
operate until the battery has been fully charged again.
Battery cells outside operating temperature between -20°C
and +60°C (-4°F to 140°F). The motor can be used again
when the temperature has stabilized.
Charging will continue when the cell temperature is
between 0°C and +45°C (32°F to 113°F).
Contact Torqeedo Service and notify them of the error
code.
Contact Torqeedo Service.