Personalization - Electrolux WA SL2 E 102 Benutzerhandbuch

If the OVERDOSAGE symbol lights up
at the end of the programme, it indi-
cates that too much detergent has
been used.
9.4 - Options: PREWASH
SENSITIVE , EXTRA RINSE
9.5 - DOOR
• This symbol indicates if the door can be
opened:
– the symbol is on: the door cannot be
opened. The appliance is performing a
washing programme.
– the symbol is off: the door can be
opened. The washing programme is fin-
ished.
9.6 - TIME SAVING
9.7 - The display shows the following infor-
mation:
• Duration of the selected programme
– After selecting a programme, the dura-
tion is displayed in hours and minutes
(for example
culated automatically on the basis of
the maximum recommended load for
each type of fabric.
– After the programme has started, the
time remaining is updated every minute.
• Delay start
– The selected delay (20 hours max) set
by means of the relevant button ap-

PERSONALIZATION

Acoustic signals
The machine is provided with an acoustic
device, which sounds in the following cases:
• at the end of the cycle
• in the event of operating problems.
By pressing the 3 and 4 buttons simultane-
ously for about 6 seconds, the acoustic sig-
nal is deactivated (except for the events of
operating problems). By pressing these two
buttons again, the acoustic signal is reacti-
vated.
Child safety lock
This device permits you to leave the appli-
ance unattended and not to worry that chil-
, STAIN
- symbol (Door locked)
- option symbol
. The duration is cal-
pears on the display for about 3 sec-
onds (for example
tion of the previously selected pro-
gramme is displayed.
– The DELAY START symbol will appear
,
on the display.
– The delay time value decreases by one
unit every hour and then, when re-
mains 1 hour, the time decreases ev-
ery minute.
• Incorrect option selection
– If an option which is not compatible
with the set wash programme is selec-
ted, the message Err is displayed for
about 2 seconds and the yellow light of
button 7 starts blinking.
• Alarm codes
– In the event of operating problems,
some alarm codes can be displayed,
for example
to do if...»).
• End of the programme
– When the programme has finished a
blinking zero
symbol disappears and the door can
be opened.
9.8 - DELAY START
9.9 - CHILD SAFETY LOCK
dren might be injured by or cause damage
to the appliance.
This function remains able also when the
washing machine is not working.
There are two different ways to set this op-
tion:
• Before pressing button 7 : it will be impos-
sible to start the machine.
• after pressing button 7 : it will be impossi-
ble to change any other programme or op-
tion.
To enable or disable this option press simul-
taneously for about 6 seconds buttons 4
and 5 until the symbol 9.5 appears or disap-
pears on or from the display.
electrolux 35
), then the dura-
(see chapter «What
is displayed, the DOOR
- symbol
- symbol