Indicator Pilot Lights; First Use; Personalization; Acoustic Signals - Electrolux LAVAMAT 74650 A3 Benutzerhandbuch

8
• symbol on: the door cannot be opened. The appliance is running or the appliance has
stopped with water left in the tub.
• symbol off: the door can be opened. The washing programme is finished.

Indicator pilot lights (10)

If the OVERDOSAGE (OVERDOSERING SURDOS
AGE) pilot light 10.1 goes on at the end of the
programme, it indicates that too much deter
gent has been used.
When the appliance is performing additional rin
ses the EXTRA RINSE (EXTRA SPOELEN RINCAGE
PLUS) pilot light 10.2 illuminates. To add an ad
ditional rinse, please see chapter «Select an addi
tional rinse».

FIRST USE

• Ensure that the electrical and water connections comply with the installation instruc
tions.
• Remove the polystyrene block and any material from the drum.
• Before the first wash, run a cotton cycle at the highest temperature without any laun
dry in the machine, to remove any manufacturing residue from the drum and tub.
Pour 1/2 a measure of detergent into the main wash compartment and start the machine.

PERSONALIZATION

Acoustic signals

The machine is provided with an acoustic device, which sounds in the following cases:
• at the end of the cycle
• in the event of operating problems.
By pressing the 3 and 4 buttons simultaneously for about 6 seconds, the acoustic signal
is deactivated (except for the events of operating problems). By pressing these 2 buttons
again, the acoustic signal is reactivated.

Child safety lock

This device permits you to leave the appliance unattended and not to worry that children
might be injured by or cause damage to the appliance.
This function remains able also when the washing machine is not working.
There are two different ways to set this option:
• Before pressing button 8 : it will be impossible to start the machine.
• after pressing button 8 : it will be impossible to change any other programme or option.
To enable or disable this option press simultaneously for about 6 seconds buttons 4 and
5 until the symbol 7.1 appears or disappears on or from the display.