Error Messages And Information Indicated By The Device Led; Restore Factory Settings - HomeMatic HM-Sec-MDIR-3 Bedienungsanleitung

8.3 Error messages and information
indicated by the device LED
Flashing code
Slow orange
flashing
Fast green
flashing
Long green
lighting
Long red lighting
Slow red flashing
Fast red flashing
Red, green and
orange lighting
9

Restore factory settings

The factory settings of the device can be restored. If
you do this, you will lose all your settings.
To restore the factory settings of the motion detector, please
proceed as follows:
Press and hold the teach-in button (F) on the motion de-
•
Meaning
Motion detector in
teach-in mode
Teaching-in active
Teach-in
successful
Teach-in failed
Stage before
resetting to
factory settings
Factory settings
of the device are
being restored
LED test display
Restore factory settings
Solution
Put the device you want to
teach-in into teach-in mode
(see sec. "6.4 Teaching-in"
on page 46).
Please wait until
teaching-in is completed.
You can continue
operation.
Please try again.
Press and hold down the
teach-in button to restore
the factory settings.
You can continue
operation.
Once the test display
has stopped, you can
continue.
55