HomeMatic HM-Sec-MDIR-3 Bedienungsanleitung Seite 47

This enables you to adapt the switching command at the ac-
tuator to every brightness level, without needing to involve the
Homematic Central Control Unit.
For example, if you want to teach-in the actuator so that it will
only switch when it is dark, and you want to do this without
using the Homematic Central Control Unit, the sensor must
be exposed to said darkness for at least 48 minutes. The
teach-in procedure is then performed.
Once the batteries have been inserted brightness
values are not available straightaway, so the specified
detection times must be observed as a minimum.
If you would like to teach-in the motion detector to one or more
Homematic devices, you must put the devices to be linked into
teach-in mode. To do this, proceed as follows:
During teach-in, please make sure you maintain a
distance of at least 50 cm between the devices.
You can cancel the pairing procedure by briefly press-
ing the teach-in button again. This will be indicated by
the device LED lighting up red.
If no teach-in operations are carried out, teach-in mode
is exited automatically after 20 seconds. If other devices
are also in teach-in mode, they will be taught-in.
Activate the teach-in mode of your motion detector.
• Teaching-in without a brightness threshold: Briefly
press the teach-in button (F). The device LED (E) starts
to flash orange.
Start-up
47