6.4.2 Teaching-In To A Homematic Central Control Unit - HomeMatic HM-Sec-MDIR-3 Bedienungsanleitung

If the motion detector has already been taught-in to a
Homematic Central Control Unit and is thus blocked for
direct teach-in, it can still be put into teach-in mode as
described above, but the device LED (E) will light up
red for 2 seconds when the teach-in button (F) is
pressed. Direct teach-in is not possible.

6.4.2 Teaching-in to a Homematic Central Control Unit

Your device can be conveniently
• controlled and configured (directly via the CCU2 user in-
terface or an app),
• connected directly to other devices or
• used in the central control unit programs
by using the Homematic software "WebUI". Therefore, your
motion detector has to be taught-in to the Homematic Central
Control Unit first. New devices are taught-in to the Central
Control Unit via the Homematic "WebUI".
As soon as a device has been taught-in to a Central
Control Unit, it can only be connected to other compo-
nents via this unit.
Each device can only be taught-in to one Central
Control Unit.
During teach-in, please make sure you maintain a
distance of at least 50 cm between the Homematic
devices and the Central Control Unit.
Start-up
49