Control Panel - Wamsler WP 01 Bedienungsanleitung

WP01_2015_de_en_fr_it_V2
4.6

Control panel

The stove has a digital display for the control of different functions. The functions of the buttons
are described in what follows.
Step
After connecting to the power supply, the configuration menu
(once) appears in the display.
Set the language using ↑↓.
Confirm with "Menu OK".
The current time and date have to be set.
"Menu OK" (pressing briefly) changes between hours and minutes
(blinks correspondingly).
"Menu OK" (pressing long) changes to day. Set day using (↑↓).
Confirm with "Menu OK".
If needed, set for an external room temperature sensor.
Selection is possible between a room temperature sensor
integrated in the stove, an external room temperature sensor and
an indoor thermostat that could act as a breaker or contactor.
"konf ok" appears after completion of these settings.
Subsequent change:
You can return to the CONFIG Menu using Power-OFF-Power-ON
+ "Menu OK", and change settings. Operation hours, consumed
pellet quantity and all parameters such as switching times, output
levels, control type, etc. are saved.
Switch on the Switch on the stove for start-up.
stove The ignition program starts.
Upon start-up the stove runs in "manual" mode in later
modifications to the operation mode previously started.
Press the button
If the flame temperature sensor detects a considerable increase of
for 2 seconds
the firebox temperature during the start phase, the stove is
considered to be ignited and switches to the normal mode of
operation.
START-UP
Description
Appears after renewed "Menu OK" → "standby"
36 / 94
Display menu
with "Menu OK"
= output level
= Temperature value
(according to set
operation mode)