JUMO dTRANS T02 PCP Betriebsanleitung Seite 37

... of a more general nature
H
If none of the parameters can be altered, then you may have
locked the operation on the instrument through the setup
program. Please check the setting with the help of the setup
program.
The instrument settings can only be changed when "Oper-
ating level" and "Parameter level" are set to "none".
H
Both outputs (current and voltage) are always available at
the same time. However, the output that has not been acti-
vated in the setup program, or by the default setting, only
has an accuracy of approximately ± 2% of full scale.
A
The frequency output will not be operated as long as the
setup plug remains plugged in.
5 Tips ...
15