To Prevent An Accidental Fall - JVC DT-V20L3G Bedienungsanleitung

To adjust the stand height
To change the stand height, detach the stand from the monitor (☞ "To detach the stand" on page 4). Then,
change the position of the stand plate according to the stand height you want by choosing the screw holes to use.
<Higher position>
Screw holes for higher position
Stand plate
<Lower position>
Screw holes for lower position
Stand plate

To prevent an accidental fall

Fix the monitor to a wall by using strings.
Fixing the monitor
Attach the hook (not provided) to the VESA mounting holes on the rear panel (use the two holes on the upper
side) using M4 x 10 mm screws (not provided). Bind the hooks on the rear panel of the monitor to a wall or a pillar
using durable string.
VESA mounting holes
Hook and screw (M4 x 10 mm)
(not provided)
Hook (not provided)
The illustration of the monitor is of DT-V24G1.
ENGLISH
5