How To Handle Basic Operations; Picture Adjustment - JVC TM-H1700G Bedienungsanleitung

HOW TO HANDLE BASIC
OPERATIONS
BASIC OPERATION
1. Press the main power switch to turn on the power.
2. Press the POWER switch to turn on the power.
POWER
3. Press the INPUT SELECT buttons to choose input.
A B
INPUT SELECT
4. Press the VOLUME/SELECT buttons to adjust the
speaker volume.
VOLUME/SELECT

PICTURE ADJUSTMENT

1. Press select buttons corresponding to the item
you want to adjust.
CHROMA CONTRAST
PHASE BRIGHT
2. Adjust with the VOLUME/SELECT buttons.
VOLUME/SELECT
LCT1092-002A-H(EN)
ON : Power turns ON. (Power indicator: lit)
Green: The main power is ON, and the monitor's
power is ON (in the normal operation mode).
OFF : Power turns OFF. (Power indicator: unlit)
Orange : The main power is ON, but the monitor's
power is OFF (in the standby mode)
Unlit : The main power is OFF.
Select video/audio signals input to terminals on the rear
panel. The selected button lights in green.
INPUT
Terminals on the rear panel
SELECT
Video signal input
buttons
1
Input A
VIDEO A terminal
(VIDEO)
2
Input B VIDEO B terminal
(VIDEO Y/C)
VIDEO B (Y/C) terminal
Note:The Y/C (S-video) terminal has priority.
Press this button to display the speaker volume level on the
screen.
+ : The Built-in speaker volume is increased. (00
– : The Built-in speaker volume is decreased. (50
* Screen indication will disappear about 10 seconds after operating.
* The on-screen display goes off when you press MENU button.
The item you select is displayed on the screen.
1
Chroma control : Press the CHROMA/PHASE button once.
2
Phase control : Press the CHROMA/PHASE button twice.
3
Contrast control : Press the CONTRAST/BRIGHT button once.
4
Brightness control : Press the CONTRAST/BRIGHT button twice.
* Pressing the CHROMA/PHASE button and CONTRAST/BRIGHT button
alternately while the item is shown on screen restores the previous status.
When no item is shown on screen, CHROMA and CONTRAST have priority.
VOLUME/SELECT button
Items
–
CHROMA
lighter
(Chroma)
PHASE
reddish
(Phase)
CONTRAST
lower
(Contrast)
BRIGHT
darker
(Brightness)
* Screen indication will disappear about 10 seconds after operating.
* The on-screen display goes off when you press MENU button.
9
About the STATUS indication
● With the COLOR SYSTEM setting set
to AUTO mode, when you turn on the
power or select inputs, the color
system indication appears for about
3 seconds on the screen while PAL or
Audio signal input
NTSC signals are being detected.
It does not appear when receiving a
AUDIO A terminal
B/W signal or when no signal is input.
Refer to page 9 for more information
AUDIO B terminal
about COLOR SYSTEM setting and
page 10 for more information about
STATUS indication setting.
[ 50)
[ 00)
VOLUME
PHASE
PHASE
Notes:
● Phase control is effective only in the
NTSC color system mode.
+
● Chroma control is not effective when
receiving B/W or when no signal is
deeper
input.
● When CHROMA is adjusted to "–40,"
greenish
the picture becomes less colorful.
● "NO EFFECT" is displayed (for about
higher
3 seconds) when your selected
function has no effect.
● To change the display position on
brighter
screen, set UPPER or LOWER with
ADJ. BAR POSI.
02.4.25, 9:48 AM
STATUS indication
(PAL or NTSC)
PAL
00 ~ 50
: 20
– +
UPPER
–40 ~ +40
: 00
: 00
+
–
LOWER
7